NEOSPRAY Universal Handpiece Lubrication Oil Spray 500ml

Reduces friction between moving parts, leading to quieter and more efficient performance during dental procedures.
Minimizes the formation of debris within the handpiece, preventing blockages and ensuring consistent functionality.
Creates a protective barrier on internal components, safeguarding them from moisture and preventing corrosion.
Significantly lowers the wear rate of handpiece components, leading to fewer repairs and replacements.
Helps your devices run smoothly over time, saving costs on frequent replacements and ensuring consistent performance.

The NEOSPRAY Universal Handpiece Oil Spray is an eco-friendly solution for maintaining your dental instruments. Designed to protect and care for your valuable handpieces, this spray ensures precise lubrication and cleaning exactly where it’s needed, all without the use of harmful CFCs (chlorofluorocarbons).

With NEOSPRAY you can efficiently maintain turbines, air motors, shanks, and heads, reducing time, cost, and effort in your daily practice. This versatile spray is suitable for all Airotor DMI instruments, offering a one-stop solution for thorough cleaning and lubrication, ensuring your equipment remains in peak condition.

Category: Lubricant
Type: Handpiece Lubricant
Form: Spray
Usage Type: Manual
Suitable For: All slow and high speed handpieces
Quantity – 500ml

1 x 500ml NEOSPRAY

Prepare the Handpiece: Detach the high-speed handpiece from the dental unit. Ensure the handpiece is clean and free from debris before lubricating.
Apply the Lubricant: Shake the NEOSPRAY canister well before use. Identify the two large holes on the handpiece; locate the smallest of the two. Attach the spray nozzle to the canister, and insert it into the smallest hole. Press the nozzle to inject the lubricant, ensuring it lightly pours out of the other hole. This indicates sufficient lubrication.
Run the Handpiece: Reattach the lubricated handpiece to the dental unit. Run the handpiece for approximately 10 seconds to distribute the lubricant evenly and remove any excess. This process ensures that the handpiece is properly lubricated and ready for use.
Final Check: Remove the handpiece from the unit and wipe off any excess lubricant. Your handpiece is now clean, lubricated, and ready for the next procedure.

Brief Guide to Clean Your Endomotor:-
Step 1- Detach the contra-angle from the motor hand-piece and clean the surface
Step 2- Connect one end of the nozzle (comes with the motor) to NEOSPRAY and the other (black ring end) to the base of the contra-angle. They should fit well.
Step 3- Cover the contra-angle surface with tissue paper and while holding the NEOSPRAY bottle upright- spray for 2-3 seconds with full pressure.
Step 4- Keep wiping off the debris that oozes out of the shank side and repeat until clear oil comes out.
Step 5- Wipe off excess oil from the surface and position the contra-angle vertically for 2-3 hours to allow excess oil to drain out.
Step 6- Shrink-wrap the contra-angle in sterile barrier packages. At a temperature of 135 degrees C, the sterilization time is at least 4 minutes and at 121 degrees C, it is at least 35 minutes. Drying time for at least 15 minutes.
The handle/ plastic body is NOT approved for device-based cleaning (washer-disinfector) and sterilization.